Specifications
GENERAL
Type : Active line array element
Transducers : 4x Coaxial 12” Neodymiun magnet driver with 3” voice coil + compression driver with 2” voice coil
Frequency Response (1) : 90 Hz – 18 kHz (-6 dB)
Maximum SPL (2) : 141 dB peak
Coverage : 100° H / 30° V or 30° H / 100° V + digital adjustment with Electronic Beam Steering
Connectors : Analog: 1x XLR (bal) input signal + 1x XLR (bal) parallel output.
Digital: 1x XLR AES3 input
Control : Remote control with dedicated PC software via Ethernet
DIGITAL SIGNAL PROCESSOR
Built-in DSP : Input gain, delay up to 2 s, Full parametric IIR filters (Peaking, Shelving, Hi/Lo pass, Hi/Lo Butterworth),
FIR filter for digital beam steering Level and Temperature remote monitoring
AMPLIFIER
Type : 4-ch., switch mode, class D
Output power : 4x 2000 W @ 4 Ω 1% THD+N
Power consumption : 600 W @ 8 Ω load, Pink noise 1/8 rated power
Protections : Over Temp. (Power Limiting – Thermal Shutdown), Short Circuit/Overload Output Protection, Power Limiting,
Clip Limiter/Permanent Signal Limiter, High Frequency Protection
Operating range : 100-240V AC, 50-60 Hz with PFC
Mains connector : powerCON with link inlet
HANDLING AND FINISHES
Dimensions (W x H x D) : 1170 x 350 x 200 mm (46 x 13.8 x 7.9 in)
Weight : 52 kg (114.64 lb)
Material : Stainless Steel
Color : Black, Custom RAL
REGULATIONS
IP Rating : IP53
Notes for data:
(1) With dedicated preset
(2) Maximum SPL is calculated using a signal with crest factor 4 (12dB) measured at 8 m then scaled at 1 m
New materials and design are introduced into existing products without previous notice.
